Especially needed when leaving the debugger or during debug unit power-up.
ARM Debug Interface Architecture Specification ADIv5.0 to ADIv5.2
tells to clock the data through SW-DP to either :
- immediate start a new transaction
- continue to drive idle cycles
- or clock at least 8 idle cycles
Implement last option to favour correctness over slight speed decrease
Implement only for adapters where we assemble the seq_out_parity in our code,
as on firmware, ftdi and jlink. Hopefully the high level adapters do it right.
Reverts 2c33cde63fe779d3019fe8f63dd4420cb960bbfe and
cde7726b8730242cd40a9974d129b46af80c68af
It seems, writing to DHCSR fails silent when the device is sleeping.
Reading DHCS during sleep may return nonsense.
Repeated write may at some point catch the device running and succeed.
With devices sleeping for long time and running on faster clock the
chance for a successful hotplug gets smaller.
- Try hard to halt a sleeping device
- Prepare vector catch and enable all debug units by TRACENA
- Release reset
- Apply device specific fixes
-- STM32F7: Store old value of DBGMCU_CR, enable debug in sleep in
DBGMCU before reading PIDR and restore DBGMCU on detach.
Signed-off-by: Uwe Bonnes <bon@elektron.ikp.physik.tu-darmstadt.de>
Firmware BMP with ENABLE_DEBUG=1 will print WARN and INFO as before.
PC-Hosted BMPwill alway print to stderr. Warn is printed unconditional,
INFO, GDB, TARGET, DONGLE and WIRE will print if their appropriate bit in
cl_debuglevel is set via the -v verbose command line argument.
INFO will go to stdout with -t or -l.
Thanks to Dave Marples <dave@marples.net> for input.
- Issue only one reset. Start with SRST. Only if not seen, use SYSRESETREQ
- Wait for release of DHCSR_S_RESET_ST before issuing more commands
- Add timeout to catch reset line stuck low
- Remove AP errors
Adds a target driver for Microchip SAM D51 / E5x family.
Tested on SAMD51G19A and SAMD51J19A. According to the datasheet, the
D51 / E5x family share the same core feature set, differing only in the
addition of CAN (E51) or ethernet controllers (E53/54). All members of
the family should be equivalent from a debug and programming perspective.
This is will make debugging earier if this does happen, rather than
dereferencing the null pointer (or passing it to memcpy, or worse).
blackmagic PR #475
* Accept prefixes of the words 'enable' and 'disable'
* Prevent silent failures on parse errors
* Print status after flag changes
* Fix missing includes
Support for Kinetis KE04 8KiB, 64KiB and 128KiB variants in nxpke04.c
Target monitor commands for sector and mass erase.
Changes to kinetis.c MDM-AP target to support KE04.
Only KE04Z8 tested in HW.
These extra cycles are needed by some CPU, e.g. STM32L0x1 to cross the SWCLK
/HCLK domains. Revert insufficient #373 also tackling that problem.
Thanks to Thorsten von Eicken for pointing out.
