This adds support for the NXP S32K148. This is an automotive-grade part
that is derived from the Kinetis line, so it has a very similar
interface to other parts in the family.
Signed-off-by: Sean Cross <sean@xobs.io>
**Summary**
Modifications to fix flash support on the lpc546xx:
- fix IAP entrypoint to be `0x03000204`, not the value at that address
- add a reset and attach sequence before erasing flash sectors. there's
little documentation around this, but experimentally, erasing sector 0
fails when the ROM bootloader is mapped to it (on reset). stepping the
chip once and attaching is enough to snap the chip out of it, permitting
flash erase on sector 0.
- add a few test commands to the lpc546xx table (read_uid, erase/write
sector, etc).
- write the magic CRC value when writing to sector 0
(`lpc_flash_write_magic_vect`).
- move the lpc546xx probe to before the lpc43xx probe, to prevent
getting the lpc546xx into Lockup when reading an illegal memory location
during lpc43xx probing
Fixes#786.
I don't 100% understand the reset/load sequence of this part, but these
changes are sufficient to program and debug the part now.
I didn't do a detailed analysis of what pyocd (via st-link hardware
adapter) and segger jlink do to handle the same, but both of those
worked without modification, so there's some difference in the
sequence they're using.
**Testing**
Verified I can now successfully erase and write an executable in sector
0 (and other sectors).
Verified the new commands work correctly.
Especially needed when leaving the debugger or during debug unit power-up.
ARM Debug Interface Architecture Specification ADIv5.0 to ADIv5.2
tells to clock the data through SW-DP to either :
- immediate start a new transaction
- continue to drive idle cycles
- or clock at least 8 idle cycles
Implement last option to favour correctness over slight speed decrease
Implement only for adapters where we assemble the seq_out_parity in our code,
as on firmware, ftdi and jlink. Hopefully the high level adapters do it right.
Reverts 2c33cde63fe779d3019fe8f63dd4420cb960bbfe and
cde7726b8730242cd40a9974d129b46af80c68af
This adds support for the NXP S32K118. This is an automotive-grade part
that is derived from the Kinetis line, so it has a very similar
interface to other parts in the family.
Signed-off-by: Sean Cross <sean@xobs.io>
It seems, writing to DHCSR fails silent when the device is sleeping.
Reading DHCS during sleep may return nonsense.
Repeated write may at some point catch the device running and succeed.
With devices sleeping for long time and running on faster clock the
chance for a successful hotplug gets smaller.
- Try hard to halt a sleeping device
- Prepare vector catch and enable all debug units by TRACENA
- Release reset
- Apply device specific fixes
-- STM32F7: Store old value of DBGMCU_CR, enable debug in sleep in
DBGMCU before reading PIDR and restore DBGMCU on detach.
Signed-off-by: Uwe Bonnes <bon@elektron.ikp.physik.tu-darmstadt.de>
* stm32h7: Don't tc_printf from flash functions
Receving an 'O' packet while flashing confuses GDB and then
weird stuff happens.
* Replace tc_printf with DEBUG_WARN
