Fixes: https://github.com/libopencm3/libopencm3/issues/234
uses the new mechanisms introduced to address a similar problem on F7.
Tested on a medium density part (0x429) that returns the same ids as
before, tested on a high density part that now _doesnt_, but that's now
correct :)
Latest versions of all reference manuals refer to the address as SPIx_BASE, and
simply name some of the individual registers as SPI_I2SXXXX. Likewise, the
interrupts are simply SPIx, not SPIx/I2Sx. Rather than hacking more duplicates
into the F0 and L0 parts where this was turning up, remove the pointless _I2S_
from SPI2/SPI3 and make it all consistent
Compile tested only, with the examples collection.
Signed-off-by: Karl Palsson <karlp@tweak.net.au>
Fixes#331Fixes#347
When compiling with all warnings enabled, some defines can lead to
warning due to missing unsigned type suffix:
warning: integer overflow in expression [-Woverflow]
This fix should not affected behavior at all, since calculation with
such overflows lead to the same actual address when writing to that
location. However, it makes the warning disappear and also defines
the right data type for a memory location.
This pulls out all the common header definitions for the F1, L1, F4 and F37x
parts. It's verified against the datasheet for F2 as well, but we don't have
any good F2 test boards or any support for that yet. (The F2 header would be
_exactly_ the same as the F4 header, so it's a target for a future round of
unification, not this one)
Tested with f1, f4 and l1 examples from the examples repository.
Add memorymap entries for ST calibration data, the vref internal, and the temp
sensor at 30C and 110C for the parts that provide this data.
F1 and F2 do not appear to have this anywhere.
STM32L1 has a different set of offsets, not just a different base
address, so we can't have common registers definitions. Also, out of
F0,F1,F2,F3,F4,L1, only the F1 has the odd note about 2x16bit registers
and 2x32bit registers with one 16bit register marked as "This field
value is also reserved for a future feature." Therefore, replace the
awkward reading out as multiple words and just copy them in.
F0,F2,F3,F4 were missing definitions altogether.
This does _not_ attempt to address the problem of the mismatched base
addresses for Medium+ and High Density L1 parts.
Updated the documentation so that it appears in all families
Also added it to the L1 area, but is untested. An addition to the memorymap
allows commonality and a #ifdef added to the spi_common_all code to
exclude the case of SPI3 for L1 and F0 as SPI3 doesn't exist in those.
An rcc dispatch header was added to remove same code from the spi header.
