According to RM0090, page 301, paragraph 11.13.12 Note. (For F4, for F1 and F3 is it in the corresponding manuals)
The JSQR are filled always ending at SQR4 ie for those lists we must set this list:
(A) -> JSQ4 = A,
(A,B) -> JSQ3 = A, JSQ4 = B,
(A,B,C) -> JSQ2 = A, JSQ3 = B, JSQ4 = C,
(A,B,C,D) -> JSQ1 = A, JSQ2 = B, JSQ3 = C, JSQ4 = D,
The readed values are in correct order, starting from JDR1:
(A) -> JDR1 = A,
(A,B) -> JDR1 = A, JDR2 = B,
(A,B,C) -> JDR1 = A, JDR2 = B, JDR3 = C,
(A,B,C,D) -> JDR1 = A, JDR2 = B, JDR3 = C, JDR4 = D,
We currently default to "-mfloat-abi=hard -mfpu=fpv4-sp-d16" for M4F cores, and
and variations of "-mfloat-abi=soft" for the others. Keep the M4F default, and
move others to no FP flags for consistency, but allow overriding these flags
via the FP_FLAGS environment variable.
Signed-off-by: Alexandru Gagniuc <mr.nuke.me@gmail.com>
Because most changes are internal to a function in exti.c I am leaving
the macro checks in there, otherwise we would end up with a bunch of
code duplication if we used the dispatch system used otherwise
throughout the stm32 part of the library. I bet it could be split up
into more granular functions resulting in more generic code that we
could run through the dispatch system. But I am leaving that as an
excersize for later.
- Additional frequency configuration (48Mhz, for usb use!)
- FLASH latency decreased (too unnecessarily low before)
- Rcc functions to change usb freq prescaler.
Very few functions can be shared (~ 3). A possible solutions is to move
i2c_common_all to i2c_common_f124, create i2c_common_all and move f3/i2c to i2c_common_f3. Who agrees?
- Makefiles of other stm32s updated accordingly.
- f3/rcc.c updated to some definition changes.
- f3/flash.c removed in order to use flash_common_f234.c to comply with new organization.
